Confirm whether the specifications of the breeding cooling fan and prime mover meet the order requirements, and whether all the accessories are complete.

Check whether the power supply (voltage, switch, etc.) and wiring are in line with the electrical requirements and whether the wiring is correct.

Check whether there is condensation water, dust and other debris in the cooling fan and pipeline of the breeding. If so, they need to be cleaned up to avoid major failures when the livestock fan starts.

Confirm that the anchor bolts, the main body of the breeding cooling fan, the various attachments and attachments, and the connection parts of the connection pipes are tightened as required.

Check whether each part is correct. For couplings or belt-driven breeding cooling fans, check the couplings or pulleys, whether the V belt is installed ##, and whether the coaxiality between the breeding cooling fan shaft and the motor shaft meets the requirements.

Check whether the apricot bearing lubricating oil (grease) is sufficient and intact. If there is oil supply, test run for 2h first, and measure whether the oil temperature and oil pressure are normal.

For aquaculture cooling fans with water-cooled bearings, check whether the water supply to the cooling water pipeline is abnormal.

Manually rotate the cooling fan shaft and prime mover shaft to check whether the apricot rotation is smooth and confirm that the element is abnormal.

Rotate the prime mover separately, confirm that the rotation direction of the prime mover is consistent with the rotation direction of the cooling fan, and confirm that there is no abnormality on the prime mover side.

For belt-driven breeding cooling fans, check whether the tension of each V-belt is consistent.

When using a coupling that requires lubricating sleeve lubrication, verify that the lubricating oil is acceptable.

Check whether the regulating door or valve ## is open or closed, and if there is any abnormal action. The inlet and outlet R regulating door of the breeding cooling fan, the centrifugal type is fully closed, and the axial flow type is fully open, and the starting load is .

For breeding cooling fan with forced oil supply device for bearing. Make sure that the oil quantity of the fuel tank, the fuel tank and the oil pipeline are clean and free, the rotation direction of the oil pump, the water supply and drainage mechanism of the oil cooler and the interlocking mechanism are normal.